![]() How do I configure the gateway to set up the static IP address and link it to the Synology device? And in doing so, are there any other gateway security settings (e.g., firewall) that I need to be aware of? By setting up a static IP address, I don't want to make the gateway less secure. So I assume I can pick an IP address that is not being used, say .252, and make it a static IP address. The IP addresses for these devices range from .65 thru .103. My Private Network DHCP Info range of .64 to .253įurther down on the same screen, I can see the devices that are linked to my gateway, either via ethernet or wifi. They have static IP addresses from Spectrum (98.x.x.x) but when they came out and installed the system (Arris. Im working with a customer to get an automation system setup with remote access to an internal 192.x.x.x IP. Using a web browser to look at the gateway setings, I first go to Settings > LAN. I just found this sub, so i thought Id post this here after posting to homenetworking too. And I think I have to set it up on the gateway first. I think I know how to set up a static IP address on the Synology device, but I do not know how to set it up on the gateway. I want to set up a static IP address so that the gateway always talks to the Synology NAS via the same IP address. I've connected a Synology NAS via ethernet cable directly to the gateway. I have a 2Wire 3801HGV gatewey from AT&T.
0 Comments
Leave a Reply. |